CAMBER ARM KIT
The vehicle must be lifted completely off of the ground and remain as such during the entire installation process.
- 2 MODEL S CAMBER ARMS
- 21mm SOCKET
- 21mm WRENCH
- 10mm SOCKET
Begin my removing leveling sensor followed by both 21mm bolts labeled 1 and 2 on Figure 1. Please remove the bolts in that order but do not take out the arm until leveling sensor has been removed to prevent damage.
Remove 10mm bolt securing height level sensor holder to factory arm as shown in Figure 2.
Prior to installing, ensure arm is set to factory length by putting a bolt in each side with factory arm. The bolts should go in freely with no tension. Install height level sensor holder to Unplugged arm.
Reinstall arm in the orientation as seen above. The turnbuckle should be outboard with the Unplugged logo upright and the height level sensor holder at the bottom. Insert arm and ensure both bolts are in prior to torquing down. Reinstall height level sensor arm onto holder.
- HEIGHT LEVEL SENSOR HOLDER: 5FT-LBS
- OUTBOARD 21mm BOLT: 103 FT-LBS
- INBOARD 21MM BOLT: 95 FT-LBS
PLEASE CALL UNPLUGGED PERFORMANCE IF YOU HAVE ANY QUESTIONS OR REQUIRE FURTHER ASSISTANCE. PLEASE DO NOT MODIFY ANY COMPONENTS DURING INSTALL WITHOUT CONTACTING UNPLUGGED PERFORMANCE.